CentOS Boot Fix | Acquiring Satellites..

CentOS Boot Fix

Published October 3rd, 2007 in Linux. 2 Comments

I ran into this on a HP dc7700 that I was install CentOS 5 on.

Symptom: CentOS 5, Fedora Core 5, and possibly RHEL5 the install hangs with the message ACPI: Assume root bridge [\_SB_PCI0] bus is 0

Solution: Start the install process with: linux all-generic-ide pci=nommconf

2 Responses to “CentOS Boot Fix”

Feed for this Entry Trackback Address

1 Björn Apr 1st, 2008 at 5:09 am

Symptom: CentOS 5, Fedora Core 5, and possibly RHEL5 the install hangs with the message ACPI: Assume root bridge [\_SB_PCI0] bus is 0

Solution: Start the install process with: linux all-generic-ide pci=nommconf

I have tried this solution but CentOs gives me te same problem:ACPI: Assume root bridge [\_SB_PCI0] bus is 0 and then is hangs. I there an other solution for this problem? Thx
2 jlechuga2000 Jul 17th, 2008 at 3:57 pm

I have the same hardware and CentOS 5.2 installs OK with this:

linux pci=conf1

try this! i read a lot to found this!!!

works the same with suse 10.3 !!!!

Leave a Reply